Differences

This shows you the differences between two versions of the page.

--- netapp_management [2021/01/19 13:01] – andonovj
+++ netapp_management [2021/01/19 13:15] (current) – [System] andonovj
@@ Line 52: / Line 52: @@
 {{:netappincreasevolspace.jpg?500|}}
+====Create Aggregate====
+====Create Volume====
 =====Privilege Levels=====
 On NetApp, we have several privilege levels:
@@ Line 145: / Line 148: @@
 cluster1::*>
 </Code>
+====Legacy====
+Legacy mode is the old ONTAP7- level of syntax. Unlike the other privileges, the legacy mode operate on the node, rather than the entire cluster level.
+To enter into legacy mode, use the following command:
+<Code:bash|Elevate to Legacy>
+cluster1::*> system node run cluster1-01
+Type 'exit' or 'Ctrl-D' to return to the CLI
+cluster1-01>
+</Code>
+Where cluster1-01 is the cluster node which you want to manage.
+====System====
+System level is very low level management and it is usually done via the Netapp personal instructions.
+First we have to set the diagnostic level privilege, as before and then we can enable also system level.
+<Code:bash|Elevate to System level>
+cluster1::> set -privilege diagnostic
+Warning: These diagnostic commands are for use by NetApp personnel only.
+Do you want to continue? {y|n}: y
+cluster1::*> systemshell local
+  (system node systemshell)
+[email protected]'s password:
+Warning:  The system shell provides access to low-level
+diagnostic tools that can cause irreparable damage to
+the system if not used properly.  Use this environment
+only when directed to do so by support personnel.
+cluster1-01%
+</Code>