Differences

This shows you the differences between two versions of the page.

--- netapp_storage_install [2021/01/04 19:13] – [NetApp Software] andonovj
+++ netapp_storage_install [2021/01/07 11:16] (current) – andonovj
@@ Line 6: / Line 6: @@
-=====Configure=====
+=====Create Cluster=====
 In this section we will configure the physical and software component of the Netapp. Well physical...as most as we can, given that it is virtualized :D
 Firstly, following our topology from the Vyos, we need 7 network adapters connected to the different networks.
@@ Line 82: / Line 82: @@
 {{:netappcommandlinecomplete.jpg?500|}}
-====Disk Addition====
-Now, in order to make some use of our Virtualised storage, we need to add some disks.
-Before that however, we need to unlock the diag user. Diag user is a special type of user, used for administrative purposes.
-{{:undefined:netappunlockdiaguser.jpg?400|}}
+=====Joining to a Cluster=====
+Now, to joing a NetApp simulator to our previously created cluster, we need to do a little change.
+====Change Serial====
+That change is to change the serial number, because if we don't when it will try to join, it will try to check the serial and if it sees two machines with the same serial it will fail.
+So, at the begining of the booting, don't press enter, just press any other buttom and follow the instructions:
+{{:netappchangeserialnumber.jpg?500|}}
+Once that we changed the serial the serial we can continue as before with the booting:
+====Joining====
+To join a cluster, we have to again interupt the booting menu (the 2nd one, not the 1st one as the previous section) and again choose option 4) (Clean installation)
+Repeat the steps from the creation of the clustert with the exception of the step for: "Create or Join"
+This time choose JOIN:
+{{:netappjoin.jpg?500|}}
+====Obtain the Private IP====
+After that, we will be asked to enter the private Cluster network IP from node 1.
+So go to Node 1 and issue the following command to obtain the IP:
+{{:netappmasteripinterfaces.jpg?500|}}
+So enter this IP in the configuration on the 2nd node:
+{{:netappjoinprivateclusternetwork.jpg?500|}}
+That should work and we should be given the login prompt:
+{{:netappjoined.jpg?500|}}
+====Assign Disks====
+Repeat the steps from the previous section for the disk addition, reboot and assigning of the disks, like the 1st node.