Differences

This shows you the differences between two versions of the page.

--- netapp_storage_install [2021/01/05 11:16] – [Obtain the Private IP] andonovj
+++ netapp_storage_install [2021/01/07 11:16] (current) – andonovj
@@ Line 6: / Line 6: @@
-=====Configure=====
+=====Create Cluster=====
 In this section we will configure the physical and software component of the Netapp. Well physical...as most as we can, given that it is virtualized :D
 Firstly, following our topology from the Vyos, we need 7 network adapters connected to the different networks.
@@ Line 82: / Line 82: @@
 {{:netappcommandlinecomplete.jpg?500|}}
-=====Disk Addition=====
-Now, in order to make some use of our Virtualised storage, we need to add some disks.
-===Enter System Shell===
-Before that however, we need to unlock the diag user. Diag user is a special type of user, used for administrative purposes and the most important thing is that it allows us to enter into the system shell:
-{{:undefined:netappunlockdiaguser.jpg?500|}}
-====Create Data Disks====
-Now that we are in the system shell we are ready to create the disks as follows:
-  * Change the Path
-  * Create the disks
-{{:netappcreatedatadisks.jpg?500|}}
-====Create SSD Disks====
-To add SSD disks, use the same command, just instead of type 23, we will add disks with type: 35
-{{:netappcreatessddisks.jpg?500|}}
-After that, we can safetly reboot the machine. Once the machines boots, we have to fix a common problem with the simulator.
-The simulator often crashes because of the insufficient space in the root aggregate. So, we have to assign all disks this node and remove & disable the snapshots
-====Assign Disks & Remove / Disable snapshot====
-{{:netappassigndisksremovesnapshots.jpg?500|}}
-After that we can reboot the server:
-{{:netappreboot.jpg?500|}}
-Once rebooted, we can assign disk to the root aggregate and increase the space in the volume:
-====Add disk & Increase space on the Volume====
-Firstly, we have to add the disk to the volume:
-{{:netappadddisktorootaggregate.jpg?500|}}
-Once we have that we can increase the storage of the volume. Firstly, I will give him bigger number (1G) so I will see with how much I can increase it (in my case 888MB)
-{{:netappincreasevolspace.jpg?500|}}
 =====Joining to a Cluster=====
@@ Line 163: / Line 119: @@
 {{:netappjoined.jpg?500|}}
-====Reassign Disks====
+====Assign Disks====
-In my case it was automatic, but you might need to reassign the disks to the second node as well, using the following command:
+Repeat the steps from the previous section for the disk addition, reboot and assigning of the disks, like the 1st node.
-<Code:bash|Reassign disks>
-cluster1::> storage disk assign -all true -node cluster1-02
-</Code>